RFC 7405 PROPOSED STANDARD SYNTAX · ABNF

Case-Sensitive String Support in ABNF

ABNF prefixes for writing quoted strings that must match case exactly or ignore case.

On rfc-editor.org ↗
PUBLISHED
December 2014
AUTHORS
P. Kyzivat
STREAM
IETF
BUILDS ON
RFC 5234 — ABNF
CASE-SENSITIVE PREFIX
%s
CASE-INSENSITIVE PREFIX
%i
CHARACTER SET
US-ASCII
DOI
10.17487/RFC7405

RFC text

Contents
Original text · RFC Editor View on rfc-editor.org ↗
Internet Engineering Task Force (IETF)                        P. Kyzivat
Request for Comments: 7405                                 December 2014
Updates: 5234
Category: Standards Track
ISSN: 2070-1721


                 Case-Sensitive String Support in ABNF

Abstract

   This document extends the base definition of ABNF (Augmented Backus-
   Naur Form) to include a way to specify US-ASCII string literals that
   are matched in a case-sensitive manner.

Status of This Memo

   This is an Internet Standards Track document.

   This document is a product of the Internet Engineering Task Force
   (IETF).  It represents the consensus of the IETF community.  It has
   received public review and has been approved for publication by the
   Internet Engineering Steering Group (IESG).  Further information on
   Internet Standards is available in Section 2 of RFC 5741.

   Information about the current status of this document, any errata,
   and how to provide feedback on it may be obtained at
   http://www.rfc-editor.org/info/rfc7405.

Copyright Notice

   Copyright (c) 2014 IETF Trust and the persons identified as the
   document authors.  All rights reserved.

   This document is subject to BCP 78 and the IETF Trust's Legal
   Provisions Relating to IETF Documents
   (http://trustee.ietf.org/license-info) in effect on the date of
   publication of this document.  Please review these documents
   carefully, as they describe your rights and restrictions with respect
   to this document.  Code Components extracted from this document must
   include Simplified BSD License text as described in Section 4.e of
   the Trust Legal Provisions and are provided without warranty as
   described in the Simplified BSD License.

Table of Contents

   1.  Introduction  . . . . . . . . . . . . . . . . . . . . . . . .   2
   2.  Updates to RFC 5234 . . . . . . . . . . . . . . . . . . . . .   2
     2.1.  Terminal Values - Literal Text Strings  . . . . . . . . .   3
     2.2.  ABNF Definition of ABNF - char-val  . . . . . . . . . . .   4
   3.  Security Considerations . . . . . . . . . . . . . . . . . . .   4
   4.  Normative References  . . . . . . . . . . . . . . . . . . . .   4
   Author's Address  . . . . . . . . . . . . . . . . . . . . . . . .   4

1.  Introduction

   The base definition of ABNF (Augmented Backus-Naur Form) supports US-
   ASCII string literals.  The matching of these literals is done in a
   case-insensitive manner.  While this is often the desired behavior,
   in some situations, case-sensitive matching of string literals is
   needed.  Literals for case-sensitive matching must be specified using
   the numeric representation of those characters, which is inconvenient
   and error prone both to write and read.

   This document extends ABNF to have two different types of US-ASCII
   string literals.  One type is matched using case-sensitive matching,
   while the other is matched using case-insensitive matching.  These
   types are denoted using type prefixes similar to the type prefixes
   used with numeric values.  If no prefix is used, then case-
   insensitive matching is used (as is consistent with previous
   behavior).

   This document is structured as a set of changes to the full ABNF
   specification [RFC5234].

2.  Updates to RFC 5234

   This document makes changes to two parts of [RFC5234].  The two
   changes are as follows:

   o  Replace the last half of Section 2.3 of [RFC5234] (beginning with
      "ABNF permits the specification of literal text strings") with the
      contents of Section 2.1.

   o  Replace the <char-val> rule in Section 4 of [RFC5234] with the
      contents of Section 2.2.

2.1.  Terminal Values - Literal Text Strings

   ABNF permits the specification of literal text strings directly,
   enclosed in quotation marks.  Hence:

         command     =  "command string"

   Literal text strings are interpreted as a concatenated set of
   printable characters.

   NOTE:

   The character set for these strings is US-ASCII.

   Literal text strings in ABNF may be either case sensitive or case
   insensitive.  The form of matching used with a literal text string is
   denoted by a prefix to the quoted string.  The following prefixes are
   allowed:

         %s          =  case-sensitive
         %i          =  case-insensitive

   To be consistent with prior implementations of ABNF, having no prefix
   means that the string is case insensitive and is equivalent to having
   the "%i" prefix.

   Hence:

         rulename = %i"aBc"

   and:

         rulename = "abc"

   will both match "abc", "Abc", "aBc", "abC", "ABc", "aBC", "AbC", and
   "ABC".

   In contrast:

         rulename = %s"aBc"

   will match only "aBc" and will not match "abc", "Abc", "abC", "ABc",
   "aBC", "AbC", or "ABC".

   In the past, the numerical specification of individual characters was
   used to define a case-sensitive rule.

   For example:

         rulename    =  %d97 %d98 %d99

   or

         rulename    =  %x61.62.63

   will match only the string that comprises only the lowercase
   characters, abc.  Using a literal text string with a prefix has a
   clear readability advantage over the old way.

2.2.  ABNF Definition of ABNF - char-val

         char-val       =  case-insensitive-string /
                           case-sensitive-string

         case-insensitive-string =
                           [ "%i" ] quoted-string

         case-sensitive-string =
                           "%s" quoted-string

         quoted-string  =  DQUOTE *(%x20-21 / %x23-7E) DQUOTE
                                ; quoted string of SP and VCHAR
                                ;  without DQUOTE

3.  Security Considerations

   Security is truly believed to be irrelevant to this document.

4.  Normative References

   [RFC5234]  Crocker, D. and P. Overell, "Augmented BNF for Syntax
              Specifications: ABNF", STD 68, RFC 5234, January 2008,
              <http:/www.rfc-editor.org/info/rfc5234>.

Author's Address

   Paul Kyzivat
   Massachusetts
   United States

   EMail: pkyzivat@alum.mit.edu

ISO Plain Language

On this page
PROBLEMABNF quoted strings were case-insensitive, so a case-sensitive rule had to list character codes individually.
MECHANISMThe RFC adds the %s prefix for case-sensitive strings and the %i prefix for case-insensitive strings; no prefix keeps the existing case-insensitive behavior.
WHY IT MATTERSGrammar authors can write case-sensitive US-ASCII literals directly. RFC 7405 updates RFC 5234.

§1Why ABNF Needed a Change

Augmented Backus-Naur Form (ABNF) is used to describe protocol syntax. Under RFC 5234, quoted US-ASCII string literals match without regard to case.

When a rule needed case-sensitive matching, authors had to use numeric character values. RFC 7405 adds prefixes so that both case-sensitive and case-insensitive string literals can be written directly.

ABNF quoted strings used to ignore letter case. The old way to require exact case was to write each character as a number.

§2.1The %s and %i Prefixes

The prefix %s marks a case-sensitive string, while %i marks a case-insensitive string. A quoted string with no prefix remains case-insensitive, preserving the earlier behavior.

For example, %s"aBc" matches that exact capitalization. A string such as "abc" or %i"aBc" matches regardless of capitalization.

Use %s when every letter must have the stated case. Use %i, or no prefix, when uppercase and lowercase versions should both match.

ABNF CASE-SENSITIVE AND CASE-INSENSITIVE STRINGS
String literal examples
%s"aBc" ; matches exactly aBc
%i"aBc" ; matches without regard to case
"abc"     ; same as %i"abc"

§2.2Updates to RFC 5234

RFC 7405 replaces the discussion of literal text strings in Section 2.3 of RFC 5234 and replaces the char-val rule in Section 4. The new rule permits both case-insensitive and case-sensitive quoted strings.

The RFC says numeric character specifications remain available, but prefixed literal strings are easier to read. Its Security Considerations section says security is believed to be irrelevant to this document.

The update changes two parts of RFC 5234 to allow the new prefixes. Existing strings without a prefix keep their earlier meaning.

§4References